Products > Test Equipment

Tektronix Prism 3002 & 3001 TekLink 174-1391-00 or 174-1152-00 cable data needed

<< < (3/3)

inotarobot:
Been just looking through my 6 Various Tektronix Prism Logic Manual when I came across a VERY interesting WARNING against using theo the 174-1391-00 at 9 inches verses the Teklink cable 174-1152-00 at 4ft

On page 14 of Tektronix Publication 070-7696-05 titled 'Application Module & Expansion Mainframe Installation Manual', there is the following bold NOTE mid page. I quote


--- Quote --- "Older expansion mainframes were shipped with both 48 inch and a 9 inch Teklink cable.
  FOR optimum timing correlation between modules installed in the two mainframes, use the 48 inch TekLink cable to connect the mainframes. Use of the 9 inch cable is NOT recommended."
--- End quote ---

Since their seems little to no online information on the Teklink setup for the Prism 3001 & 3002 in relation to the 3002E (expansion fame) I felt it worth adding this note to my posting.

abtr1995:
Hi,
Can you specify the name of the connector shown? I need the connector’s male to usb cable. Is that possible? Please help. You can send photographs and links to buy it if available. Thank you in advance.
Regards,
Thakur

helius:
It is usually called 'MDR36', but you aren't going to find any cables that adapt a TekLink interface to USB.

Are you trying to connect to a parallel printer? There may be IEEE 1284-C to USB converters but driver support would be an issue.

abtr1995:
Hi helius,
Thank you so much for your input. I actually have 02 SSDs sata which are interfaced via a pcb and then connected to a mdr 26 pin connector. It is a vintage setup and is hence difficult to take out data from the SSDs. Please help me if you have any inputs pertaining to the above mentioned issue.
Regards,
Thakur

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod