Products > Test Equipment
TEKTRONIX TDS 350 - option 14 board / or from compatible model.
(1/1)
alitronix:
Hi, I'm looking for a "module" option 14 (to buy) for my tek tds 350.
All I want is the VGA output , for some reasons that is what I want to use from the module.
If someone have to sell/donate I'm interested.
I'm looking also for a 350 defective one to buy, from were I want to pull it out the option.
Any suggestion or info/link is good for me.
Thank you,
Alin
this is for Europe.
alitronix:
ok... what I miss? I asked in wrong place?
any information about the subject in good for me.
Thank you.
james_s:
It's fine to ask here, the likely answer is that nobody has one of these available, they were relatively rare in my experience.
Fortunately for a TDS300 series you don't need a module, the VGA signal is available from a header on the main PCB so all you need is a VGA connector, a PC slot bracket from a video card and a ribbon cable to assemble your own.
alitronix:
yes , I confirm it, is not very clear if you look at the service manual,
but after a close look at the board and in service manual and also hooked up an another oscilloscope on the connector I figure it out how to connect the VGA DB connector.
I put some pics below maybe someone it interested in, there is also the pin-out configuration of the connector.
james_s:
I think it's deliberate that it's not very clear, Tek wanted to sell the expensive option, they didn't want people just hacking in a connector.
Looks like a nice clean job.
Navigation
[0] Message Index
Go to full version