Products > Test Equipment
Tektronix TDS3034 update
coromonadalix:
i think they have a final firmware 3.41 but before that version you had another version where you could add some hacks / functions etc ..
search here for tds-1000-2000-3000-bw-hack and other threads
i had to create the floppies for the upgrade, and it was a nightmare to find blank floppies lolll
Javier1028:
Thank you for all your answers,
I updated the firmware to 3.41 and now the trace is dark blue as expected.
Now I will change the SRAM...
YetAnotherTechie:
before you remove the ram, check to see if you have a valid MAC address and write it down. You will need to write it back on the ram, or the newtork will not work.
There's plenty of info detailing how to do this, search the forum. 3.41 doesn't allow you to upgrade bandwith, you need 3.39 at most.
Javier1028:
Thank you, YetAnotherTechie,
How can I check the mac address? I checked in the forum, but it's not very clear to me. I don't have ethernet card, but I guess it could be installed in the future.
About the bandwidth upgrade, I have seeing some videos, and it seems that all that I have to do is to install a hacked firmware, am I right?
Best regards,
Javier
coromonadalix:
indeed you need to hack the scope before upgrading to v3.41 if i recall
Navigation
[0] Message Index
[*] Previous page
Go to full version