Products > Test Equipment

Tektronix TDS3xxx replacing backlight, power supply, fan etc. HDMI out. (photos)

<< < (3/3)

Miti:

--- Quote from: JusTideaFIX on July 05, 2024, 10:59:46 am ---I'm glad you were able to successfully repeat the project.
If possible, post photos of how you placed the board.
For myself, just in case, I made an additional 10cm ground wire for the scope chasis (see image).

--- End quote ---

I haven’t installed it yet, just tested it, as I’m waiting for a longer flat cable from AliExpress, but here it is.
I made a braket that goes on the empty space beside the backlight inverter. I’ll post the stl file once I’m sure it is a good fit.

Cheers,
Miti

vinovino:
Regarding power supply replacement using different model and brand,
Do you encounter a problem like feeling a slight electricity when touching the BNC Terminals of the unit?

JusTideaFIX:

--- Quote from: vinovino on July 17, 2024, 07:36:08 am ---Regarding power supply replacement using different model and brand, Do you encounter a problem like feeling a slight electricity when touching the BNC Terminals of the unit?

--- End quote ---
No, I have not encountered such a problem. All devices in the workplace are connected to each other by a grounding contact through schuko sockets. This contact is not connected anywhere, since there is no PE conductor in the building.

Miti:
This is the final install.

Edit: I uploaded the stl files.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod