Products > Test Equipment

Test Equipment Anonymous (TEA) group therapy thread

<< < (2038/27435) > >>

bd139:
No problems here either. Once something went missing for a week and turned up but I’ve sent and received about 300 packages over the years without problems.

Specmaster:

--- Quote from: bd139 on May 02, 2018, 01:17:14 pm ---


Dial calibration is about right ... 1/2% off on the higher ranges which is pretty normal for these.

 :-+

--- End quote ---
That range switch looks as if its just been installed, very nice.

bd139:
Indeed. I was quite pleased when I saw the condition. There is some damage to the front panel mounts as you can see in the right of that picture. Doesn't affect operation though and isn't visible when it's closed so meh.

GerryBags:
Well, I just found the 2 resistors with the biggest drift in my limited experience. From 15 Ohms one had drifted to 355K and the other is either open or so high none of my meters can read it.  :o No scorching, or anything visible other than very slightly discoloured leads. The current inrush limiters they were across can't have been too happy with the situation. :-\

Specmaster:

--- Quote from: GerryBags on May 02, 2018, 04:53:37 pm ---Well, I just found the 2 resistors with the biggest drift in my limited experience. From 15 Ohms one had drifted to 355K and the other is either open or so high none of my meters can read it.  :o No scorching, or anything visible other than very slightly discoloured leads. The current inrush limiters they were across can't have been too happy with the situation. :-\

--- End quote ---
The ones that you can't read, do you know the value its supposed to be or checked the colour bands, it might be a Giga ohm resistor, I found one of these recently on a scope, never found one before.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod