Products > Test Equipment
Test Equipment Anonymous (TEA) group therapy thread
tggzzz:
--- Quote from: Brumby on May 07, 2018, 01:26:19 am ---Now I'm going to have to see if I can find "Those Magnificent Men in their Flying Machines"....
My favourite piston engine aircraft are the Spitfire and the Lancaster bomber. I always find a smile when I see the Spitfire in any movie scene ... even when they have them flying into space attacking an orbiting spaceship, complete with aerial acrobatic manoeuvres (but that's Dr Who for you).
--- End quote ---
... and most other SF films albeit with rather distorted spitfires :(
Specmaster:
--- Quote from: bd139 on May 06, 2018, 04:23:57 pm ---Slacking sunday - not. After much dicking around I decided to do an LCR meter properly and design a PCB and get it made up. Mainly because codeine for foot injury + manually routing board by hand on paper turned into something Dali would have come up with.
Schematic capture done. Now to fuck around trying to spend 9 hours entering footprints for latching changeover switches and working out how to cram it all in a Hammond 1599.
Step 1 ...
Parts are chosen for economy not necessarily optimum for the job :)
--- End quote ---
Nice, is this going to be a 2 or 4 wire system?
bd139:
Nice photos BTW.
It's a 2 wire as it's doing only L & C. R I don't care about.
Having some problems with KiCad at the moment which appears to be drunk and dumping the resistors all over the shit in 3d mode:
tautech:
--- Quote from: bd139 on May 07, 2018, 08:57:32 am ---Nice photos BTW.
It's a 2 wire as it's doing only L & C. R I don't care about.
Having some problems with KiCad at the moment which appears to be drunk and dumping the resistors all over the shit in 3d mode:
--- End quote ---
:-DD
I was gunna say something about penis fingers ......but I won't. :-X
Brumby:
Your resistors have been centred over one of their mounting holes, rather than aligned to both of them.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version