Products > Test Equipment

Test Equipment Anonymous (TEA) group therapy thread

<< < (2089/27435) > >>

mnementh:

--- Quote from: BravoV on May 08, 2018, 03:48:06 am ---
NOS .. NIB ... TON ... whatever ...  for sure $20 gone .. :palm:

Teaser ...  :P

--- End quote ---

Do I see "Goodwill Industries" on the paper in the baggie, and a hand-scribbled sticker on top of the unit?  :-DD This does not bode well...  ;)


mnem
*Toddles off, even dedder now*


Ero-Shan:

--- Quote from: Neomys Sapiens on May 06, 2018, 09:28:53 pm ---
--- Quote from: tautech on May 06, 2018, 08:29:28 am ---
If you fall into a hole where you can't find parts......ask here !
Many of us have old IC's and especially in my junk pile of old PCB's 1m2 x 500mm high.....dozens and dozens of old IC's.
A good few tubes of new assorted stuff too.

--- End quote ---
Same here.

--- End quote ---
I always considered myself to be rather good stuffed with parts ...
So, of course, I add myself to this list also.

A long, long time ago, I got some rather big machines that had TTLs without end. But as they were all soldered and I had no real means to unsolder them, I finally threw them away (my parents gave some strong advice about filling up the house with trash). Wish I still had them.

Mr. Scram:

--- Quote from: bitseeker on May 08, 2018, 02:25:33 am ---That was a pleasant surprise. I didn't expect B+K to have parts available, let alone at a reasonable price. Good to know.

I'm still kind of annoyed with B+K. A lot of their "modern" equipment that I've seen either in person or via repair videos has been low to medium quality yet still sold at only slightly lower than Keysight prices (i.e., major brand surcharge).

Your experience with parts availability, though, helps lower my annoyance level a bit.

--- End quote ---
I've seen Shahriar's teardowns and repairs of a few bits of BK stuff and he seems quite satisfied with the quality.

Specmaster:

--- Quote from: BravoV on May 08, 2018, 03:48:06 am ---NOS .. NIB ... TON ... whatever ...  for sure $20 gone .. :palm:

Teaser ...  :P

--- End quote ---
Its a signal or a function generator?

med6753:
Houston, we have a trace! The 110V supply is fixed and the scope came up. Checked all the supply voltages and they are OK. But the trace is dull even with full intensity. So I'll have to dive into the CRT circuits and see what's up. I have a suitable HV probe and I respect the HV area especially since I cut my teeth on vacuum tube circuits. Hopefully it will just need some adjustments.

There's life in the old beast after all!  :-+ :-+ :-+

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod