Products > Test Equipment

Test Equipment Anonymous (TEA) group therapy thread

<< < (24886/27437) > >>

bd139:
Damn. The thread was interesting when he wasn’t in it  :-DD

med6753:
What a modern day snake oil salesman looks like.  ::)

Specmaster:

--- Quote from: mnementh on June 27, 2022, 10:01:55 pm ---
--- Quote from: Vince on June 27, 2022, 07:29:45 pm ---
--- Quote from: Cubdriver on June 27, 2022, 07:45:25 pm ---
--- Quote from: capt bullshot on June 27, 2022, 07:02:21 pm ---
--- Quote from: mnementh on June 27, 2022, 07:00:42 pm ---
--- Quote from: AVGresponding on June 27, 2022, 06:58:50 pm ---
--- Quote from: dl6lr on June 27, 2022, 06:09:25 pm ---
--- Quote from: Neper on June 27, 2022, 03:02:10 pm ---
--- Quote from: mnementh on June 27, 2022, 02:21:54 pm ---
--- Quote from: tggzzz on June 27, 2022, 02:08:00 pm ---
--- Quote from: Cerebus on June 27, 2022, 12:30:50 pm ---
--- Quote from: tggzzz on June 27, 2022, 09:52:25 am ---... 2400nm was unarmoured, 300nm armoured. ...
--- End quote ---
I don't think 2.4 micrometres of armour is going to make much difference.  >:D
--- End quote ---
Sigh. The other nm in common use all around the world, i.e. not just USA.
But you knew that :)
--- End quote ---
So newton-metres then...? >:D

--- End quote ---
Nautical miles?

--- End quote ---
Never mind...

--- End quote ---
Not me!

--- End quote ---
numpty modulated.   

--- End quote ---
near mexico

--- End quote ---
https://youtu.be/HE6EP3Z0PSU -Pat
--- End quote ---
night marish....
--- End quote ---
no manual.    >:D   

mnem
why do I smell burning pitchforks and sharpened torches...?  :o


--- End quote ---
Nah, No Money

McBryce:
So I printed the PH-163 casing. Fit's perfectly and seems relatively safe to use, but the creator neglected to mention which terminals he used. Has anyone an idea what terminals would fit the PH-163 pins? Or what terminals these are in his picture? https://3dmixers.com/m/268285-ph-163-connector-hp-oval-

McBryce.



bd139:

--- Quote from: McBryce on June 28, 2022, 07:41:36 am ---So I printed the PH-163 casing. Fit's perfectly and seems relatively safe to use, but the creator neglected to mention which terminals he used. Has anyone an idea what terminals would fit the PH-163 pins? Or what terminals these are in his picture? https://3dmixers.com/m/268285-ph-163-connector-hp-oval-

McBryce.

--- End quote ---

Did you print it in PLA? It's hygroscopic. I wouldn't put mains near it.

My approach on these in the future are going to be making a blanking plate with a cable strain relief and either a dangling IEC socket or a captive mains lead.

Although I managed to avoid that at the weekend with the 400E as it had an IEC already

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod