Products > Test Equipment
Test Equipment Anonymous (TEA) group therapy thread
med6753:
--- Quote from: Vince on July 06, 2022, 08:52:29 pm ---Oh wow, that bad ?! Looks like you need not just a new spool of solder, but also a new camera ! >:D
--- End quote ---
I need a new pancreas too but that's unlikely to happen. :-//
bd139:
Find an image editing tool with white balance control on it. Click that then click the bit of the picture they’ll at is supposed to be white. Job done. 99% of the photo is the photographer not the camera
Specmaster:
--- Quote from: med6753 on July 06, 2022, 08:41:45 pm ---End of an era. I've had that same roll of 60/40 for perhaps 40 years. But as you can see it's nearly run out. So a replacement arrived today. Genuine Kester 60/40. I figure I better grab some before the nannies outlaw it. That new roll will most likely outlast me.
--- End quote ---
Holy crap, I'm in shit creek then, I've 9 of these bad boys to get through, maybe I should start to list some on eBay, cos you use way more solder than I do, and I've only recently started the first one of 10 that BD and I purchased some time ago when leaded solder was beginning to become unobtainable so we brought 10 each to keep us going >:D :-DD
bd139:
I’ve used two of the bloody things already :scared:
Mostly using some 62/36/2 Felder stuff that cost me a fortune for repairs though. 60/40 for prototype shit.
Will add it eyeball watchlist at hamfests as well.
Specmaster:
--- Quote from: bd139 on July 06, 2022, 09:05:29 pm ---Find an image editing tool with white balance control on it. Click that then click the bit of the picture they’ll at is supposed to be white. Job done. 99% of the photo is the photographer not the camera
--- End quote ---
Yeah, but to be fair to med, the label is pure white, so I think on this occasion it might just be the flash and the way it is reacting to it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version