Products > Test Equipment

Test Equipment Anonymous (TEA) group therapy thread

<< < (2546/27437) > >>

med6753:
It's out...FINALLY...for the most part. The Vertical Board on this sick 465. I just have to unsolder/tag some wires and pull the rear coaxes and it will be free. Then disassemble the range switch assemblies so I can get to the backside and clean the finger contacts. Oh and guess what? The BNC's are part of the board assembly.

BD....question...does the delay line unplug from the vertical board? It looks like a connector but it is real tight. I may have to unsolder it.

   

bd139:
Think the delay line is soldered on. If it's not one of those little coax connectors it will be

med6753:
It is soldered to the board. But now that I have everything else disconnected and tagged I have plenty of room to remove the rear switch board and work in that area. So the delay line is going to remain connected.

PA0PBZ:

--- Quote from: med6753 on July 03, 2018, 12:42:12 pm ---It's out...FINALLY...for the most part.

--- End quote ---

Holy s... that thing put up a bit of a fight isn't it?  :phew:

bd139:
Tek didn’t put a lot of thought into fixing it once it was built.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod