Products > Test Equipment
Test Equipment ET4410
<< < (4/4)
w.v.s.:
Mine is from "MUSTOOL" with a "FREG" button, but seems to have and updated, not fully compatible firmware. It identifies with:  ELEC,ET4410         ,V6.00.2232.019,V1.12.2103.008,...
HKJ:

--- Quote from: w.v.s. on May 13, 2023, 12:29:26 pm ---Mine is from "MUSTOOL" with a "FREG" button, but seems to have and updated, not fully compatible firmware. It identifies with:  ELEC,ET4410         ,V6.00.2232.019,V1.12.2103.008,...

--- End quote ---

You can probably still use it with TestController, you just need to edit the #idstring line
w.v.s.:

--- Quote from: HKJ on May 13, 2023, 04:08:02 pm ---
You can probably still use it with TestController, you just need to edit the #idstring line

--- End quote ---

Thank you! I actually did that before the post above. It was then recognized, but I got some error messages, because it returned measurement data, while TC expected a mode. This seems a bit surprising, because the relevant behavior is consistent with most of the SCPI-command list provided by Martin72. The VERSION? command throws an error with my unit.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod