Products > Test Equipment

Test Equipment ET4410

<< < (4/4)

w.v.s.:
Mine is from "MUSTOOL" with a "FREG" button, but seems to have and updated, not fully compatible firmware. It identifies with:  ELEC,ET4410         ,V6.00.2232.019,V1.12.2103.008,...

HKJ:

--- Quote from: w.v.s. on May 13, 2023, 12:29:26 pm ---Mine is from "MUSTOOL" with a "FREG" button, but seems to have and updated, not fully compatible firmware. It identifies with:  ELEC,ET4410         ,V6.00.2232.019,V1.12.2103.008,...

--- End quote ---

You can probably still use it with TestController, you just need to edit the #idstring line

w.v.s.:

--- Quote from: HKJ on May 13, 2023, 04:08:02 pm ---
You can probably still use it with TestController, you just need to edit the #idstring line

--- End quote ---

Thank you! I actually did that before the post above. It was then recognized, but I got some error messages, because it returned measurement data, while TC expected a mode. This seems a bit surprising, because the relevant behavior is consistent with most of the SCPI-command list provided by Martin72. The VERSION? command throws an error with my unit.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod