Products > Test Equipment

Testing the NEW SIGLENT SDG1022X-PLUS, output 100Mhz!!

<< < (4/6) > >>

Tankj:

--- Quote from: KungFuJosh on December 12, 2024, 04:14:39 pm ---

--- Quote --- I didn't do the firmware upgrade to the TH2830 in the end, it still stays on TH2830 thing.

--- End quote ---
It's worth it if you ever need the higher frequencies or DC bias. If not, it doesn't make much of a difference if you have one of the newest firmwares where the arbitrary frequency values also work on the 2830.

The only difference is the BNC ports AFAIK. Most of the white ones have the 3 split with mediocre chamfer. The newest ones/black ones have the 4 split with better chamfer.

--- End quote ---

The main consideration that stop me to install the ST firmware is the impact of second-hand value. I'm thinking to sell it(TH2830) for the newer version, or go for a TH2840A something when I have enough money >:D But this don't have much value other than self-satisfaction, most of my work is in the audio range.

Maybe it will has some other HW difference, like the newer CPUs or FPGAs, like the newer SDS1000XHD has (better Zynq processor).
 I'd like to see someone has the black version and teardown >:D >:D
 

Tankj:
50Mhz harmonics


100Mhz harmonics


Much better than the previous tests!

tautech:
Nice work, tidy setup.  :clap:

Please tell, what's with the white knob on the SDG1022X Plus encoder ?
Easier to see ?

KungFuJosh:

--- Quote from: Tankj on December 12, 2024, 07:28:10 pm ---The main consideration that stop me to install the ST firmware is the impact of second-hand value. I'm thinking to sell it(TH2830) for the newer version, or go for a TH2840A something when I have enough money >:D But this don't have much value other than self-satisfaction, most of my work is in the audio range.

--- End quote ---

The ST2832 is more valuable than the TH2830. I sold my upgraded TH2830 on eBay (listed as upgraded TH2830 to ST2832), and did just fine. 😉 The buyer was very happy too.

Switching back and forth is easy anyway, if you have a TH2830 firmware to go back to.

Tankj:

--- Quote from: tautech on December 12, 2024, 07:45:46 pm ---Nice work, tidy setup.  :clap:

Please tell, what's with the white knob on the SDG1022X Plus encoder ?
Easier to see ?

--- End quote ---

Thanks.

yes I found the large knob a bit fiddly to operate when needed to turn it quickly. the little white one is easier to see too.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod