Products > Test Equipment
Testing the NEW SIGLENT SDG1022X-PLUS, output 100Mhz!!
Tankj:
--- Quote from: KungFuJosh on December 12, 2024, 07:53:58 pm ---The ST2832 is more valuable than the TH2830. I sold my upgraded TH2830 on eBay (listed as upgraded TH2830 to ST2832), and did just fine. 😉 The buyer was very happy too.
Switching back and forth is easy anyway, if you have a TH2830 firmware to go back to.
--- End quote ---
I don't have the TH version firmware, guys from TH refuse to give me new firmwares :-[ maybe they have some policies on this. If I can't go back, better to leave the choice to the next user ^-^
Tankj:
For anyone who wants to try it, the 5X and 10X sinewave Arb files are attached!
It should make your signal 5X or 10X faster if your signal generator support that fast of rise time.
tautech:
--- Quote from: Tankj on December 12, 2024, 08:06:07 pm ---
--- Quote from: tautech on December 12, 2024, 07:45:46 pm ---Nice work, tidy setup. :clap:
Please tell, what's with the white knob on the SDG1022X Plus encoder ?
Easier to see ?
--- End quote ---
Thanks.
yes I found the large knob a bit fiddly to operate when needed to turn it quickly. the little white one is easier to see too.
--- End quote ---
Hmmm, is using the keypad unsuitable ?
Tankj:
--- Quote from: tautech on December 12, 2024, 09:10:46 pm ---Hmmm, is using the keypad unsuitable ?
--- End quote ---
No, The keyboard is good and quite useful, The only complaint for me is that all buttons are a bit heavy, needs more force to press than usual.
IMO, it is more convenient to use the knob when needs to continuously change paras, say frequency and amplitude. also when selecting Arbs or files.
newbrain:
--- Quote from: Tankj on December 12, 2024, 07:00:47 pm ---Did a quick test again, all settings are the same except the vertical scale to 200mV, this time 0.63Vpp on 1.6V full scale.
You are right, the noisy harmonics are gone, all tests met the specified performance. I can get even lower harmonics with 250mV vertical scale after I did the screenshots.
1kHz, all harmonics are under -65dB :-+
1Mhz, highest harmonics are around -64.5dB
25Mhz, -55dB 50Mhz harmonic
1Mhz spurious, under -77dB
--- End quote ---
Very kind of you!
Thanks a lot - I suspected as much, given my similar results with SDS804 and self built AD9954 based generator, when compared with a TinySA.
I'm not bothered by the slow rise/fall times of the SDG10?2X-plus for square waves, so I might get one in the close future.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version