Products > Test Equipment
TH2830 vs TH2832
mawyatt:
--- Quote from: KungFuJosh on July 02, 2023, 03:20:21 pm ---
--- Quote from: mawyatt on July 02, 2023, 01:24:54 pm ---Probably the usual Cal Labs here in US. Expect a hefty bill tho
--- End quote ---
I've never sent anything for cal before, so I have no idea who is trustworthy. What is hefty? Over $200? More?
--- End quote ---
A good Cal lab likely charges well over $200/hr, so would expect well over $200 charge.
Best,
KungFuJosh:
--- Quote from: tv84 on July 02, 2023, 05:10:03 pm ---The patch doesn't go there near. Maybe the info is stored as ST2830 (Ax) and when the software tries to retrieve it as ST2832, it fails.
That's why I say that a direct change in the FRAM/whatever from Ax to Cx would make all good without FW patchings.
--- End quote ---
Did you swap any calls between Ax and Cx? If so, what about modding the fw so that Cx works on Ax and the other references to Ax are left alone? In other words, only change references to Cx, and leave the Ax stuff unchanged?
I think Rudi can get a memory dump of his 2832.
What about my theory about setting the ID over SCPI or USB or RS-232C? Unfortunately, I don't know jack about SCPI stuff.
Thanks,
Josh
KungFuJosh:
--- Quote from: mawyatt on July 02, 2023, 05:29:23 pm ---A good Cal lab likely charges well over $200/hr, so would expect well over $200 charge.
--- End quote ---
Hmmm. No thanks! 🤣🤣🤣
Looks like I'll calibrate it myself and call that good enough. I don't need certification, I just need it to be at least as accurate as my other meters.
tv84:
--- Quote from: KungFuJosh on July 02, 2023, 05:36:10 pm ---Did you swap any calls between Ax and Cx? If so, what about modding the fw so that Cx works on Ax and the other references to Ax are left alone? In other words, only change references to Cx, and leave the Ax stuff unchanged?
--- End quote ---
No change. That is Hollywood stuff... :)
KungFuJosh:
--- Quote from: tv84 on July 02, 2023, 05:43:50 pm ---
--- Quote from: KungFuJosh on July 02, 2023, 05:36:10 pm ---Did you swap any calls between Ax and Cx? If so, what about modding the fw so that Cx works on Ax and the other references to Ax are left alone? In other words, only change references to Cx, and leave the Ax stuff unchanged?
--- End quote ---
No change. That is Hollywood stuff... :)
--- End quote ---
Crap, Hollywood's still on strike too, so they're not going to help. 😉
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version