Products > Test Equipment

TH2830 vs TH2832

<< < (28/74) > >>

KungFuJosh:

--- Quote from: luudee on July 03, 2023, 03:39:39 pm ---I have dumps of the I2C EEPROMS (the B85RC64TA, and the AT24C512)

--- End quote ---
Awesome, thank you! Can you post them here, or are they too big?


--- Quote ---Now my unit is back in my rack, which is a huge pia to pull out ... it's not trivial ....

--- End quote ---
What kind of rack? Standard 19" or something smaller? I want to make a narrow rack for my bench gear.

Martin72:

--- Quote from: Martin72 on July 02, 2023, 03:27:09 pm ---I'll check tomorrow how many protocols are stored in our database.

--- End quote ---

Found two, the last from May2023.
After removing names and other sensitive data I´ll upload it here.
A little disappointment is that they´re using testfrequencies up to 10khz max.
But they will have their reasons to do so I guess.

luudee:


Here are the dumps of the I2C EEPROMS (the B85RC64TA, and the AT24C512)
They should be exactly 8K and 64K bytes.

luudee

KungFuJosh:

--- Quote from: mawyatt on July 01, 2023, 11:28:14 pm ---some good 0.1% low TC chip resistors

--- End quote ---

What do you consider low TC? There's a pretty huge range available. I'd like to get the best option without paying too much per resistor.

Is 25ppm/C good enough? I have some in my cart that range from 5ppm to 25ppm/C.

nctnico:
What is the spec of the LCR meter? If you want some calibration worthy standards then get parts that are 10 times better. In some designs I use 0.01% 2ppm SMT resistors as references (which are calibrated using a 6.5 digit DMM later on). These resistors are like 15 euro each from Mouser IIRC.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod