Products > Test Equipment
TH2830 vs TH2832
KungFuJosh:
--- Quote from: Martin72 on July 11, 2023, 10:05:59 pm ---If you want other frequencies inbetween, sorry man, for the next 2weeks I couldn´t get the ST2830 for measure.. ;)
--- End quote ---
Screw that, go to work! 😉
Nah, I don't need anything else. Clearly the firmware works better on your A6 hw than on my A7 hw, assuming that's the responsible difference. I wonder what's actually different. Both of the mainboards were made in 2019 or earlier.
Although it's clear that my 2830 results were more consistent with the newer TH fw.
Martin72:
--- Quote ---Screw that, go to work!
--- End quote ---
;D
Looking at your "results"...
This will probably be some correction data that does not work with your device.
The cross-check would be to load YOUR firmware on another device.
KungFuJosh:
--- Quote from: Martin72 on July 11, 2023, 10:24:01 pm ---
--- Quote ---Screw that, go to work!
--- End quote ---
;D
Looking at your "results"...
This will probably be some correction data that does not work with your device.
The cross-check would be to load YOUR firmware on another device.
--- End quote ---
My firmware was given to me from another user. I asked what his hardware ID is. If we're both A7, then that doesn't tell me anything, but if his is A6, and both work with the same newer fw, then that's at least a clue.
You could load both the TH and ST 2830 fws on your work meter if you want. You already know the ST version works fine. 😉
Martin72:
If then something is going wrong, I´m dead.. ;)
Jokes aside, with every firmware "update" the previous calibration is void.
Another thing:
--- Quote ---I'm waiting on a Mouser order
--- End quote ---
Part numbers please.. 8)
KungFuJosh:
--- Quote from: Martin72 on July 12, 2023, 12:22:19 am ---Part numbers please.. 8)
--- End quote ---
Attached is a list of what I'm using for testing the LCR.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version