| Products > Test Equipment |
| TH2830 vs TH2832 |
| << < (55/74) > >> |
| KungFuJosh:
--- Quote from: luudee on July 25, 2023, 01:27:07 pm ---If you compare it to the accuracy chart, it matched quite well .... --- End quote --- Yes, it would be nice if you could acquire the firmware so others could try it. 😉 I'm curious, can you try inductance test in the 600mH to 1H range? I'd like to see how accurate/stable it is compared to my not-so-great results. If you could compare at least 1kHz and 10kHz results, that would be awesome. Thanks, Josh |
| KungFuJosh:
I pulled a 10nH inductor off a 2nd test board, and tested it in my SMT fixture. It worked pretty well! 12nH is pretty close considering the generic test fixture, and I don't know the actual value. 😉 I had an 0603 10nH inductor also, but it was too small for my fixture to work well. |
| Martin72:
Hi, Bias on ? Why ? |
| KungFuJosh:
--- Quote from: Martin72 on July 27, 2023, 08:43:06 pm ---Bias on ? Why ? --- End quote --- It's not on. It's set at 1.5V, but it's only on when the external BIAS button is lit up red...which you can't see in a screenshot. 😉 |
| Martin72:
Ahhh... ;) 12 instead of 10nH is good, better as I expected with such a "low" testfrequency. jXL is about 6mOhm - What Rdc have the coil ? |
| Navigation |
| Message Index |
| Next page |
| Previous page |