Products > Test Equipment

TH2830 vs TH2832

<< < (70/74) > >>

Martin72:
Please report then.


--- Quote --- They should, but if they do, they'll never tell me
--- End quote ---

Same here with Hioki, East Tester... :P

KungFuJosh:

--- Quote from: Martin72 on January 14, 2024, 12:43:43 am ---Please report then.


--- Quote --- They should, but if they do, they'll never tell me
--- End quote ---

Same here with Hioki, East Tester... :P

--- End quote ---

Even Hioki? Is it cause of it being an older model? That's disappointing. Hioki at least has firmware and stuff available on their website. Tonghui is douchebags about it to everybody. It's tedious to get anything from them, and certainly nothing has been available on their website.

Martin72:

--- Quote ---Even Hioki? Is it cause of it being an older model?
--- End quote ---

This is something I hadn't even posted here in the forum, I actually got a direct response from hioki earlier this year, probably because I contacted them with my company address this time.
Previously the distributors said there was nothing for my LCR because support was discontinued in 2015.
Now Hioki themselves had replied to me and written that they don't release anything to the public.
At least they are honest.
Tonghui and East Tester lie to you directly and say they have nothing.

KungFuJosh:

--- Quote from: Martin72 on January 14, 2024, 01:09:00 am ---Tonghui and East Tester lie to you directly and say they have nothing.

--- End quote ---

Yup. Tonghui told ST their newest fw was 2021. Then I sent ST a photo of Gnome's newer firmware version. After that is when TH gave ST the 2023 fw. I dunno if that's correlation or causation, but it's certainly interesting...and ridiculous.

Martin72:
"Today" I got the new firmware for our ST2830 from Sourcetronic (the guy asked me if I knew about the new firmware through a certain "Josh"...  ;) ).
I then asked again what exactly had been changed, the question was passed on and I may get an answer soon (which I will then post here).
This is interesting because I have to pay attention to the calibration.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod