Products > Test Equipment
The attempt of a Micsig (A/S)TO11xx general purpose thread ... :-)
<< < (16/20) > >>
skander36:
Hi shakalnokturn,
What measure do you made?
On me is working but you want to do other type of measure perhaps ...
shakalnokturn:
Hello skander36,
Thanks for your screenshot, at least it got me thinking...
My bad: I haven't used this scope that much (I have too many scopes) nor read the manual enough, I was confusing the "High capture rate" and visual persistance.
I can do cursor measurements with persistance enabled but not with high capture rate enabled. The measurements then read as "-1".
skander36:
Hi, where is this setting?
Mine is STO1152, but I can't find this seeting.
shakalnokturn:
On my TO1104 it's in the bottom menu that also allows you to take screenshots and enable "all measurements", it's an icon that looks like a sinewave.
Shown to be active on my screenshot by the red "H" next to "Run".
DaneLaw:

--- Quote from: rvalente on November 11, 2021, 01:03:46 pm ---#1 - Does anyone know how many FFT points the 1104C and 1104E have? I can't find this anywhere
#2 - Can it operate without battery? This battery will die in a few years.

--- End quote ---

Aint the max "FFT points" on these Missig scopes, just the highlighted number in red' when you're in FFT.?
Something like.. TO-series around 43k and the STO (1000C series & perhaps 2000C series) around 88K and the new Joystick (STO1000 & 2000 non-C vers.) around 100k, same as the older STO-E-series which I also reckon were at 100k FFT-points.??

fx here 87.5k.?


--- End quote ---

--- End quote ---
'

A crude Mhz-dialing with an FY6900/60 SG.


--- End quote ---

--- End quote ---
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod