Products > Test Equipment

The Siglent SDG1000 and SDG800 thread

<< < (67/81) > >>

Lightages:
I fried my SDG1025 from pure stupidity by connecting the active output to around 60V . I was unable to determine which parts had been blown even with sme help from Agilent. I had to buy a replacement board in the end.

ivan747:
Hi guys, does anyone happen to know if there's a contrast/brightness adjustment on the SDG1010?

I have it sitting on a shelf overhead and the LCD angle doesn't let me see the text that's next to the 5 soft buttons. (It's white on gray).

Alternatively, is there a way to change the font color of the "skin" of the device?


For reference, I'm talking about this:

tautech:

--- Quote from: ivan747 on July 02, 2017, 11:48:44 pm ---Hi guys, does anyone happen to know if there's a contrast/brightness adjustment on the SDG1010?

I have it sitting on a shelf overhead and the LCD angle doesn't let me see the text that's next to the 5 soft buttons. (It's white on gray).

Alternatively, is there a way to change the font color of the "skin" of the device?

--- End quote ---
Not that I can find.
Yes the viewing angle from below is quite limited, probably only 20oand the menu text does indeed gray out. Your pic is interesting, I couldn't not see the yellow of Ch1, must be just something to do with your camera.
All I can suggest is to elevate the rear of the unit to get a more normal viewing angle or shift it somewhere better in your instrument stack.

ivan747:

--- Quote from: tautech on July 03, 2017, 10:02:38 am ---
--- Quote from: ivan747 on July 02, 2017, 11:48:44 pm ---Hi guys, does anyone happen to know if there's a contrast/brightness adjustment on the SDG1010?

I have it sitting on a shelf overhead and the LCD angle doesn't let me see the text that's next to the 5 soft buttons. (It's white on gray).

Alternatively, is there a way to change the font color of the "skin" of the device?

--- End quote ---
Not that I can find.
Yes the viewing angle from below is quite limited, probably only 20oand the menu text does indeed gray out. Your pic is interesting, I couldn't not see the yellow of Ch1, must be just something to do with your camera.
All I can suggest is to elevate the rear of the unit to get a more normal viewing angle or shift it somewhere better in your instrument stack.

--- End quote ---

The color distorsion is just the because of the camera.


About the viewing angle... that's tough... I was hopping somebody knew of a firmware version with a different color scheme.

Yes, I could tilt it but the multimeter that's on top of it is already tilted and it would look weird. It would also be a risk for the multimeter.

tautech:
For these tried and tested AWG's, a new firmware update:

SDG1000 series
Version: V1.01.01.39R5
http://www.siglenteu.com/gjjrj-xq.aspx?id=4035&tid=15
897 KB

Changelog
1. Fixed a few bugs

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod