Products > Test Equipment

The Siglent SDG1000 and SDG800 thread

<< < (75/81) > >>

tv84:
If that was a Lecroy, what model would it be? I can't find any Lecroy model equivalent to the Siglent SDG805...

tablatronix:
Thanks all!

I was doing something wrong, I was missing 07 install first,
yay, running latest firmware now, SD830
instek SFG2010 is channel 2

FYI, before the update,
The boot screen says siglent, but the help info screen, help page were saying wavestation, its back to siglent now.


I did not run any commands, because I cannot get a console, I am on mac. anyone know if there are drivers for osx?


Also I am getting some voltage out of the usb port, it repeatedly crashes my hub on bootup, not sure what could be wrong to cause this. The device did show up, but this seems odd and glitches my usb hub. Attached a trace.

tautech:

--- Quote from: tablatronix on January 15, 2020, 01:27:32 am ---Thanks all!

I was doing something wrong, I was missing 07 install first,
yay, running latest firmware now, SD830

--- End quote ---
:-//
Do you mean it's now a SDG830 ?
And with FW 13R9 ?


--- Quote ---I did not run any commands, because I cannot get a console, I am on mac. anyone know if there are drivers for osx?
--- End quote ---
Yes because you are USB restricted to using the EasyWave SW utility and IIRC there's a SCPI command console in there. No LAN in these models to use Telnet or Putty consoles.
Check the install notes on EasyWave as you should be able to run it in a Win VM yet don't overlook it needs NIVISA Runtime for the USB connectivity drivers.


--- Quote ---Also I am getting some voltage out of the usb port, it repeatedly crashes my hub on bootup, not sure what could be wrong to cause this. The device did show up, but this seems odd and glitches my usb hub.
--- End quote ---
With the latest FW allowing for USB boot freeze recovery the unit polls the USB port on boot looking for the recovery files and if/when not found procedes with normal boot.
Can you turn OFF the power on one port of the hub ?

tablatronix:
Yes It says sdg830, others have reported similar

I expected a serial uart, but I see now it uses a usb stack, boo

I would expect there to be a backfeed diode here or vusb to not be connected at all. Very strange. ( I thought usb boot protection meant the front usb port for usb drives. )

Ordinaryman1971:
I've got a BK PRECISION 4053 which is rebadged Siglent SDG1000, any way to change the firmware to Siglent's and to "upgrade" to 50Mhz.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod