Products > Test Equipment

Tips and Tricks: R&S RTB2000/RTM3000/RTA4000

<< < (3/10) > >>

Harjit:
If the waveform tips are orange or you see up / down arrows next to the channel number on the bottom of the screen, that means the channel was clipped when it was digitized.

Rich@RohdeScopesUSA:
This is one of my favorites for deep memory captures (works best with lots of memory turned on):

Set the waveform how you want to see it.  Adjust memory depth to an amount that gives offscreen data.
Press Stop.
Make a short swipe in the horizontal direction and the scope will automatically scroll through your waveform for you.

It can take a few tries to get proficient at it (if you don't get it right, the waveform will just move a small amount).  Sometimes helps to do it above/below the trigger level.



-Rich

Rich@RohdeScopesUSA:
If you connect a mouse (you can use a mouse and keyboard), you can use the scroll wheel on the mouse to emulate the "multi-purpose knob" on the front panel.


-Rich

Warhawk:
Please, keep going with this thread.  :-+

Rich@RohdeScopesUSA:
You can tap on the calculated cursor value and it will open the cursor menu. If you tap on the automatic measurement value it will open the measurement menu.


-Rich

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod