Products > Test Equipment

Tips and Tricks: R&S RTB2000/RTM3000/RTA4000

<< < (9/10) > >>

zitoune:

--- Quote from: Hydron on August 02, 2020, 01:09:23 pm ---Use the V/div control to expand the decode vertically, then see if it'll do it.

--- End quote ---

Thank you - indeed changing the V/div scale does work. Very handy, you can see more decoded values on the screen!

zitoune:

--- Quote from: egonotto on August 02, 2020, 02:02:24 pm ---Hello,

in the picture are not the decoded value in the table but the relative time of the single segments.

Best regards
egonotto

--- End quote ---

Yes indeed, I was looking at the decoded values on the top part of the screen.

egonotto:
Hello,

what I can get is shown in the two pictures.

Best regards
egonotto

zitoune:
Yes this is exactly what I was looking for and it is even more handy when decoding long words like in the attached screenshot (24bits I2S protocol).

Thanks.

analogRF:
I am not sure if this is the right thread for this question but my RTM3000 has started resetting the time and date when I turn it off with the hard switch at the back
(or unplug it). Everytime I power on it asks to adjust the time and date
I have looked inside and there is no battery or super cap that I can see on the main board.

Am I missing something or this is a fault I need to look into?
could be a battery or supe cap on the front panel board? I didnt disassemble that far.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod