Products > Test Equipment

Tips and Tricks: R&S RTB2000/RTM3000/RTA4000

(1/10) > >>

Rich@RohdeScopesUSA:
I thought I'd start a thread on tips and tricks for the RTB2000/RTM3000/RTA4000.  Some of these may be known already, but hopefully some are new.  I'll try to add more to this as I get time - feel free to add your tips/tricks too!   :-+

-Rich

Tap on clock opens time and date setup.


Tap on interface icon opens interface short information window (e.g. this is helpful if you need the IP address quickly).


Tap on gear wheel opens interface menu (this is more if you need to update your USB/Ethernet settings - it gives you quick access to that menu).


Tap on information window opens numeric keypad.


Tap on waveform marker to select a waveform.  Every marker is moveable.

Rich@RohdeScopesUSA:
A couple more:

You can name your device:
 SCPI: syst:name “ViliWonka”



If you tap on menu item it will increment the selection in pull down menu.


-Rich

BU508A:
Hello Rich,

thank you for this nice thread, saw two tricks which I didn't know yet.  :)

But may I ask you to increase the size of the screenshots? With some hi-res display they are a bit hard to read.

Thank you very much.

Mounty

maginnovision:

--- Quote from: BU508A on July 22, 2019, 04:29:31 pm ---Hello Rich,

thank you for this nice thread, saw two tricks which I didn't know yet.  :)

But may I ask you to increase the size of the screenshots? With some hi-res display they are a bit hard to read.

Thank you very much.

Mounty

--- End quote ---

Yea, here's what I get when I click the image. Without clicking it it's even smaller.

Rich@RohdeScopesUSA:
Sorry about that.  I'll make them larger.

-Rich

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod