Products > Test Equipment

TLA7xxx hacks (32M Depth on TLA7AA4CS enabled successful) :)

<< < (5/18) > >>

TiN:
Same version as my previous post, i updated it long ago from 4.4.

jgorsk:
Did you have any problems getting TLA server v5.1 to work with TLA client
application v6.1?

I can get client - server configuration to work only if they are both v5.1

TiN:
No, I had no issues, just had all stuff installed on v5.1 first, then just deinstall and install new 5.8 on remote PC, then did same thing with 6.0 and 6.1.
I remember there were issues with 6.x on one of my HDDs, but on another its working fine. Make sure you have NI VISA installed as well (I used it for LabView, but found that some libraries
are being used by Tektronix software as well).

jgorsk:
Thanks for the tip about NI VISA, I only have Tek VISA installed. I thought there were conflicts between Tek software and NI VISA. I'll try it.

jgorsk:
I installed NI Visa drivers on the client computer. Now I can connect to the server but the client aplication
isn't detecting any modules. Did you install NI Visa on the Tek frame as well?

That's so much for bad news. Good news is that my TLA7AA4-CS is now full option 32M.

Thank you very much TiN.   :-+

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod