RD6018 on a lower current supply - can I set an OCP current curve?

[SpottedDick]

Hi All,

So I'm currently putting together a power supply using a RD6018 and Meanwell 400W 48V 8.3A supply.

(Figures below are just for demonstration)

While at 48V, I'll only get 8.3A, at 24V, I could get 16A.

Is it possible to set an OCP curve for this setup on the RD6018?

Thanks in advance

[SpottedDick]

Well apparently it's not possible on the default Riden software BUT the Unisoft software adds over power protection, which will do exactly what I want