Products > Test Equipment
Trigger Data hold on Philips Meters sans DataHold Probe?
(1/1)
watchmaker:
Is there a way to trigger DataHold on meters like the PM 2525 using the Din connector pins and a standard probe?

I have looked at various pinouts for this connector but they all address 4 wire resistance and temp probes.

TIA.

Dewey
abeyer:
At least some of the models using that connector have service manuals with schematics available with the full connection details.

IIRC, pins 5-6 are an I2C bus and the data hold probe is active, sending messages on that bus which drive a bunch of relays controlling internal signal routing.
watchmaker:
Thank you.  I will look at the SMs of some of the other meters that use that probe.  I do have two other meters that hold (Flukes) and I would like to add this to the Philips.

Regards,

Dewey
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod