EEVblog® Electronics Community Forum

Products => Test Equipment => Topic started by: LittleRain on March 10, 2018, 07:05:55 am

Title: Trouble Finding Hantek 6022bl with Sigrok Pulseview Windows 10
Post by: LittleRain on March 10, 2018, 07:05:55 am

Hello everyone, new guy here.
Just got a new scope/LA, which you probably guessed is the Hantek 6022bl.
After trying their software which is really quite poor, I'm really wanting and struggling to get it to work with Pulse View.

I installed Pulse View from the exe installer, and just can not get it to find my device.
The firmware is already in the sigrok/pulseview/share/sigrok-firmware folder, and from what I understand I should be good to go.

I'd really appreciate any help I can get, I can't find much info about on how to use them together.

Title: Re: Trouble Finding Hantek 6022bl with Sigrok Pulseview Windows 10
Post by: abraxa on March 12, 2018, 04:00:21 pm

Two things that come to mind:

1) Did you set up the USB drivers with zadig?
2) You can download the Windows debug build and run it with "pulseview -l 5" (that's a lowercase L) to get debug output on the console. That will tell you what's going wrong.