| Products > Test Equipment |
| Uni-T UT139c LCD biasing and other mods |
| << < (10/10) |
| kkontak:
My UT139C meter from work (bought in 2019) is also the new board revision with the eeprom at the back of the PCB, along with the main IC (wafer under blob). I was able to read the 24C02 eeprom with my miniPRO, but it would not write. The pins were: 8 V+ 7 WP 6 SCL 5 SDA 4 VSS(gnd) I resorted to desolder the eeprom and program the new BIN file directly with a SOIC8 adapter. The changes I made were: ADDRESS OLD -> NEW 8D 07 -> 09 (Mode1 Resistance -> Continuity) 9D 09 -> 0D (Mode2 Continuity -> Resistance) FC 0F -> B4 (backlight 15s -> 180s) FB 0F -> 1E (Auto Power OFF 15m -> 30m) By default, the UT139C starts with DC on V/A modes, so I didn't need to change that, as opposed to the UT210E. For some reason, the first 9 bytes were all FF, as per DTM0660 DataSheet. I haven't seen that at other's BINs. Even my UT210E had the first 5 bytes all FF. |
| Navigation |
| Message Index |
| Previous page |