Products > Test Equipment
Uni-T UT181A and calibration
<< < (5/8) > >>
2N3055:

--- Quote from: skander36 on March 31, 2020, 08:29:42 am ---That meter was not modified , it was slaughtered . I cannot even watch it .

--- End quote ---
Biggest laugh was how guy got pissed when Joe "gently" pointed out what a hack job he did....
joeqsmith:

--- Quote from: 2N3055 on March 31, 2020, 09:56:52 am ---
--- Quote from: skander36 on March 31, 2020, 08:29:42 am ---That meter was not modified , it was slaughtered . I cannot even watch it .

--- End quote ---
Biggest laugh was how guy got pissed when Joe "gently" pointed out what a hack job he did....

--- End quote ---

Was it really all that bad....
https://www.eevblog.com/forum/testgear/uni-t-ut181a-pictures/msg746347/#msg746347
It was!!!   :-DD   
2N3055:

--- Quote from: joeqsmith on March 31, 2020, 11:27:25 pm ---
--- Quote from: 2N3055 on March 31, 2020, 09:56:52 am ---
--- Quote from: skander36 on March 31, 2020, 08:29:42 am ---That meter was not modified , it was slaughtered . I cannot even watch it .

--- End quote ---
Biggest laugh was how guy got pissed when Joe "gently" pointed out what a hack job he did....

--- End quote ---

Was it really all that bad....
https://www.eevblog.com/forum/testgear/uni-t-ut181a-pictures/msg746347/#msg746347
It was!!!   :-DD

--- End quote ---
Uni-Texas chainsaw massacre.. :-DD
CDaniel:
Sorry to say the obvious but it's a waste of money to buy an expensive Uni-T because it is cheaper than a Fluke  ;D
For AC voltage accuracy should be possible to modify some values at the true-rms converter circuit , of course in this case the AC current could be off more or less ...
Bobson:

--- Quote from: skander36 on March 30, 2020, 03:19:21 pm ---CEM 9979 use a Hycon DMM frontend with a TI cpu but use also a software calibration with no trimpot onboard .
 
--- End quote ---

Do you know how to calibrate 9979? Several years ago I managed to calibrate DC, but I've lost all the knowledge.
My 9979 says "offset left right" "key up down", but nothing changes at any range while pressing cursor keys.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod