Products > Test Equipment
UNI-T UT211B upper amp range not work
(1/1)
Romero77:
Hello, people!

This is my first post on this beautiful forum. Hope to have a useful time here!

On the problem.. I have UNI-T UT211B clamp meter. After a time, when I needed to measure amperage on 60A DC range I found out that meter don't show reading on display. On 60A AC too. Shows only zeroes.
Only low range 6000/600 mA works.
I don't see any problem on the board, when checked. Here she is:

 IMG_20221004_104725960.jpg (1158.65 kB. 2113x1189 - viewed 37 times.)

The only thing that comes to my mind is corrupt EEPROM.
I will be very, very happy if someone share his dump file of his UT221B!
Have a programmer to do the job. Thank you in advance, people!
Romero77:
In fact, after self-calibration, it turned out that the DC reads the current at 60A. Only at 60A AC range does not read and at NCV range does not make a sound when touching the power cable.
I found these problems after Duracell battery leak. But it was a little drop on the back of the board.
May be I'm missing something wrong on the board and thing is a EEPROM?
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod