Products > Test Equipment
UNI-T UT61E Multimeter teardown photos.
<< < (175/217) > >>
niclasf:
Now you can download it in the download section in bitbucket, https://bitbucket.org/foogadgets/ut61e-modification/downloads/ut61e-mod.hex

Enjoy!
groff:
Thanx  :clap:
jbuszkie:

--- Quote from: niclasf on September 22, 2015, 11:12:51 am ---I have done a combination of many of the UT61E modifications.
I have used a PIC16F688 to add more modes to the yellow and blue function buttons.


I have also added a LPF mode, but I am not sure how I can verify that it works. ::)

--- End quote ---

Do you have pictures of the mods?  I tired to go to the forum post in the foogadgets blog but it doesn't seem to work.

Thanks!

Jim
niclasf:
I have uploaded the pictures from the modification, https://bitbucket.org/foogadgets/ut61e-modification/downloads
MrMacman2u:

--- Quote from: niclasf on September 22, 2015, 11:12:51 am ---I have done a combination of many of the UT61E modifications.
I have used a PIC16F688 to add more modes to the yellow and blue function buttons. (popped out the link -MM2U)

I have also added a LPF mode, but I am not sure how I can verify that it works. ::)

--- End quote ---



Excellent... no... Outstanding work niclasf! :-+

I just bought this meter and this is, literally, an even better modification than the one I was in the middle of making using an ATTiny 85 since I wasn't going to bother breaking out the LPF!

Now I need to step it up and figure out how to hack in the temperature function using the ADF pin since that the chip supports temp too.

I'm working on other hardware upgrades as well including setting in metal inserts to use machine screws for the battery compartment and case, solid input jack upgrades to replace the cheapo splits, and installing the missing MOV's.

I'll document all the changes and post them here.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod