Products > Test Equipment

Unlocking Siglent SDS1104X-E, step by step

<< < (63/67) > >>

guho:
Does new firmware V6.1.37R8 break any unlocked features or tplink wifi? Thanks.

C.J.S.:

--- Quote from: guho on December 13, 2021, 09:43:03 am ---Does new firmware V6.1.37R8 break any unlocked features or tplink wifi? Thanks.

--- End quote ---

I updated firmware to V6.1.37R8 and can tell you that it does NOT break unlocked features or tplink wifi. But you do need to re-enter SSID (wifi access point) and PSK (wifi password) in menu Utility => I/O => WiFi Set to get wifi working again. Also I do experience a wifi connection issue (see this message for more info), but that was also the case before the FW update.

DBMandrake:

--- Quote from: guho on December 13, 2021, 09:43:03 am ---Does new firmware V6.1.37R8 break any unlocked features or tplink wifi? Thanks.

--- End quote ---
Even if it did you can always roll back to the previous version. Siglent don't seem to impose any restrictions on installing older versions over newer versions. At worst you'll just need to run the calibration again, which you should after any firmware version change anyway.

I'll probably update mine tonight, because why not.  ;)

core:
My SDS1104X-E arrived yesterday. Firmware 6.1.35R2, hw version 01-05.

I had problems with the python script. I had the following error messages :
"Traceback (most recent call last):
  File "keygen.py", line 45, in <module>
    print('{:5} {}'.format(opt, gen(SCOPEID)))
  File "keygen.py", line 31, in gen
    m = b % 0x24
TypeError: not all arguments converted during string formatting"

Because I'm not in software, I was locked in this step. I've seen that my linux distribution (Debian 10.11) had python v. 2.7.16.
So I've tried a recent live linux distribution, the python version was 3.
This solved the problem, and the script was running just fine. I didn't found this information here, so maybe this will help someone.

I've used the step-by-step guide by Jarrod, but for options AWG, WIFI, MSO I've used the SCPI commands suggested by DBMandrake (LCISL AWG,xxxxx).

Now my oscilloscope is upgraded to SDS1204X-E, and all three options are active permanent.

I've ordered the TP-LINK TL-WN725N, N150. I hope it will work.

For the moment I will check the information regarding FW 6.1.37R2, before to update.

Thank you all for sharing the information !

tautech:

--- Quote from: core on December 14, 2021, 06:15:22 pm ---
Now my oscilloscope is upgraded to SDS1204X-E, and all three options are active permanent.

I've ordered the TP-LINK TL-WN725N, N150. I hope it will work.

For the moment I will check the information regarding FW 6.1.37R2, before to update.

Thank you all for sharing the information !

--- End quote ---
That's an old version now and V6.1.37R8 and with a V2 OS update is latest.
You can find them all here:
https://int.siglent.com/download/firmwares/?ProId=12

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version