Products > Test Equipment

Upcoming Rigol DSG815/830

<< < (18/18)

GarbageCan:
Okay so I used HxD on my flash drive and was able to have success entering factory mode. The AAAB / AAAC options with riglol as said before unlock the PUM and PUG options which don't affect the maximum frequency. I tried editing the model number with :PRIVate:FACTory:MODEL to change it to DSG836 and I do see the HW Info updated. But this did not unlock the 3.6GHz. I'm reading through the scpi.xls function list that Chicken shared but I am no seeing any factory parameters for maximum frequency. Can anyone point me in the right direction of what type of license of SCPI command to use to actually bump up the maximum frequency from 1.5GHz?

chicken:
Caveat: I never tried myself to change the model number.

While the post way back says DSG836, I think the model number should be DSG830. At least that's the model that Rigol sells.

chicken:
ok, just checked on the Rigol website and there are other models including DSG836... maybe also depends on the firmware version. When I dug into my firmware, I seem to remember only seeing DSG815 and DSG830.

GarbageCan:

--- Quote from: chicken on February 27, 2024, 02:38:39 am ---Caveat: I never tried myself to change the model number.

While the post way back says DSG836, I think the model number should be DSG830. At least that's the model that Rigol sells.


--- End quote ---

Whoops, got too fixated on other people's 3.6GHz range. Thanks for the help chicken, setting it to DSG830 did the trick. Once it had power cycled it started at 3GHz. I just tested it with a spectrum analyzer and it looks good where I need it. Thank you so much for your help!!

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod