| Products > Test Equipment |
| Upgrading DSLogic Basic to Plus without EEPROM modification |
| << < (21/21) |
| bkw:
For tiny wire soldering I use single fibers from solder wick. No insulation but very tiny and always right there. --- Quote from: robca on October 20, 2023, 06:32:13 pm ---Looks promising. I had good luck with this wire for super-tiny soldering jobs https://www.remingtonindustries.com/magnet-wire/155-c-polyurethane/?_bc_fsnf=1&Wire+Size%5B%5D=40+AWG&Wire+Size%5B%5D=44+AWG. The coating is easily burnt off with a slightly hotter soldering iron, and the wire is easily solderable after that, with the coating still protecting the rest of the wire. I solder/strip 2-3mm, then snip to leave only a short solderable section of the wire. --- End quote --- |
| Navigation |
| Message Index |
| Previous page |