Products > Test Equipment

Upgrading DSLogic Basic to Plus without EEPROM modification

<< < (21/21)

bkw:
For tiny wire soldering I use single fibers from solder wick. No insulation but very tiny and always right there.


--- Quote from: robca on October 20, 2023, 06:32:13 pm ---Looks promising.

I had good luck with this wire for super-tiny soldering jobs https://www.remingtonindustries.com/magnet-wire/155-c-polyurethane/?_bc_fsnf=1&Wire+Size%5B%5D=40+AWG&Wire+Size%5B%5D=44+AWG. The coating is easily burnt off with a slightly hotter soldering iron, and the wire is easily solderable after that, with the coating still protecting the rest of the wire. I solder/strip 2-3mm, then snip to leave only a short solderable section of the wire.

--- End quote ---

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod