Products > Test Equipment
Upgrading DSLogic Basic to Plus without EEPROM modification
<< < (11/21) > >>
fonak:
Hello,
A new version of DSView 10.1 has appeared

link:
https://www.dreamsourcelab.com/download/

Changelogs:
–common
*add support for DSCope U3P100 device (100M bandwidth/1G samplerate/USB3.0 oscilloscope)
*add support for DSLogic U3Pro32 device (32 channels/1G samplerate/USB3.0 logic analyzer)
*add support for DSCope U2B100 device (100M bandwidth/1G samplerate/USB2.0 oscilloscope)
*add support for DSLogic U3Pro16 device (16 channels/1G samplerate/USB3.0 logic analyzer)
*add display of device type (USB 2.0 / USB 3.0 / Demo / File)
*add version check for FPGA firmware
*improve the default file name when saving/exporting files
*fix other display and language issue

–for logic analyzer
*extend channel support for trigger up to 32 channels
*fix issue of ps/2 decoder (#239)
*fix issue of cec decoder (#235)
*fix ID issue when export results of decoder (#237)
*fix “not” logic don’t work in advance trigger
*fix other display issues

–for oscilloscope
*improve wave shake issue when trig high freqency signals
*fix sampling point selection issue of downsampling
*add 20M bandwidth limitation for DSCope U2B100 / DSCope U3P100 devices
*improve synchronism between data acquisition and wave dispaly
*fix wave display and measurement issue when change vdiv and offset after stop
*fix capture restart issue when change offset in roll mode
*fix issue of timebase of math channel can’t be changed when waiting trigger
*fix issue of offset can’t be changed when waiting trigger
*fix clear and flicker issue of auto measurements
*fix cursor and mouse measurements issue after change samplerate when waiting trigger
*fix trigger issue when toggle between different trigger source

–for data acquisiton
*fix hardware offset setting issue
*fix mipmap issue of long time data at some case
*add cursor and mouse measurements
ceres-c:

--- Quote from: thm_w on February 16, 2020, 06:10:59 am ---Thanks, this seems to be working well. Made a small attempt at trace length matching.
edit: the 1.0.1 bitstream is working as well.

--- End quote ---
I've made the same modification, but it's still not working with the latest bitstream.
Maybe it's due to the RAM I'm using, given I have soldered the -75, which is 34MHz slower than the -6A version. Which one of the two do you have?
masterx81:
The u2b that i've upgraded had a 166mhz memory, replaced with a 6e variant and all ok. So i think that the 133mhz version can have problems
ceres-c:
Thanks @masterx81, probably my intuition was right then.
But could you please confirm you're talking about the 6A version? I could not find any 6E, while there is a 7E, which is 133MHz as well, which would probably be too slow as well.
Or maybe it was me who couldn't find it
masterx81:
6A, not 6E, you are right  :-+
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod