Products > Test Equipment

Upgrading Mainboard in Lecroy DDA-3000 (aka WavePro 7300a?)

<< < (113/155) > >>

ollopa:
The driver pack for these scopes was removed from the installer after version 6.x.  Install 6.x first or use the attached driver pack which I extracted from the 6.8 installer.

DaJMasta:
It comes up on the list as a single piece of software, but there is multiple download links.  The XStream software package comes with drivers for Magellan boards, which replaced the Aladdin boards, so the second set is needed and is easy to miss.  In the case of these scopes, the XStream package and the driver package are different installs and different downloads.

ollopa:

--- Quote from: DaJMasta on December 07, 2019, 09:43:11 pm ---In the case of these scopes, the XStream package and the driver package are different installs and different downloads.

--- End quote ---

I have never seen the driver packages available as a separate download.  Can you show where they are?

As far as I have ever seen the drivers are in the XStream installer until version 8.x, after which they disappeared.  Most of the firmware download links will have two versions and the older version still has the drivers but it's a full X-Stream installer, not just a driver pack.

analogRF:

--- Quote from: ollopa on December 08, 2019, 02:38:48 am ---
--- Quote from: DaJMasta on December 07, 2019, 09:43:11 pm ---In the case of these scopes, the XStream package and the driver package are different installs and different downloads.

--- End quote ---

I have never seen the driver packages available as a separate download.  Can you show where they are?

As far as I have ever seen the drivers are in the XStream installer until version 8.x, after which they disappeared.  Most of the firmware download links will have two versions and the older version still has the drivers but it's a full X-Stream installer, not just a driver pack.

--- End quote ---

just select 7000A and it's right there
https://teledynelecroy.com/support/softwaredownload/documents.aspx?sc=11

sixtimesseven:

--- Quote from: ollopa on December 07, 2019, 12:08:54 pm ---The driver pack for these scopes was removed from the installer after version 6.x.  Install 6.x first or use the attached driver pack which I extracted from the 6.8 installer.

--- End quote ---

Win xp pro, the chipset driver and the the 6.8 XStream drivers installed without and after installing audio, ethernet and grapics driver there were no more errors in the device manager. EDIT: I must have overlooked this late in the night. The ETH and the Aladdin Aquisition Device still show errors in the dm.
However, I still see no input and the serial number (it says: WM000001) is not correct either.

I then Installed the new v8 drivers which also installed without error. But still, there seems to be no connection to the scope hardware.

I also noticed that the sticker in the back says windows 2000 pro embedded. But I installed a non embedded win xp version. Does this matter?

Did I miss a step?
Is there a way to test the pci hardware?

EDIT: It works now. I installed the 6.x drivers once more. Now it shows the serial number, the correct option keys and the traces. Not sure if 8.x is worth it to me to try again by installing the new version.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod