Products > Test Equipment

Upgrading Mainboard in Lecroy DDA-3000 (aka WavePro 7300a?)

<< < (149/155) > >>

mophong:

--- Quote from: sixtimesseven on December 25, 2019, 10:10:05 pm ---
Conversion was really easy. I did a clean install. Then installed all the chipset / mobo drivers. Then to install the xstream drivers I downloaded moded xstream drivers from earlier in the thread and installed them via the legacy driver install option in the task manager. I had to repeat it a couple times. A "PCIe Serial" driver did not install but it does not seem to be a problem. After that get the xstream 8.x from the lecroy site and it worked.


--- End quote ---

Hi sixtimesseven, can you describe how you did install driver with legacy driver option? I have tried by failed.
Thanks.

albertr:

--- Quote from: Converter on June 29, 2021, 12:14:26 am ---I put Chrontel utility in Google Drive:

https://drive.google.com/file/d/1Wzmiiqt5ojzX7m3ZZvUnri1-ILOMH1bV/view?usp=sharing


As well as a standard BIOS for the AIMB-582QG2 motherboard (extracted from 24L6435E EEPROM):

https://drive.google.com/file/d/1huCDEH3lqOrcf_Ya-46U06flwSSFxZac/view?usp=sharing

--- End quote ---

Sergey, how did you read the board BIOS from the flash chip? Did you use any external SPI programmer?
-albertr

ollopa:
You might try booting up Linux and see if flashrom can dump the BIOS.

Converter:
-albertr, I used RT809F Programmer and 8-pin clothespin without removing the chip. But when using the Chrontel CH7511B Utility, you won't need it. If you are going to use the AIMB-581, you need to check, it may be that another controller is used there, and not the CH7511B, and then you need other utilities.

ollopa:

--- Quote from: Converter on November 06, 2021, 04:29:33 am ----albertr, I used RT809F Programmer and 8-pin clothespin without removing the chip. But when using the Chrontel CH7511B Utility, you won't need it.
--- End quote ---

I think he was asking about the BIOS flash, not the Chrontel.


--- Quote from: Converter on November 06, 2021, 04:29:33 am ---If you are going to use the AIMB-581, you need to check, it may be that another controller is used there, and not the CH7511B, and then you need other utilities.

--- End quote ---

Yes, the AIMB-581 uses the CH7308B.  If anyone has utilities for the CH7308B please post a link or send a PM!



Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod