| Products > Test Equipment |
| Upgrading the Hantek DSO4072C and DS4104C oscilloscopes bandwidth up to 250MHz |
| << < (13/15) > >> |
| Steve007iii:
--- Quote from: boogiepopgq on July 28, 2021, 03:46:55 am ---Hello, I have a NAND memory programmer and others may help you. I have a DSO4254C. I don't know if the information from there works. --- End quote --- oh yes this works for me i plan to restore the recovery partition if you are kind enough to upload it to download it it is the same motherboard what changes is the software... thanks , thanks!, thanks!, thanks!,thanks!,thanks! thank you very much. with that information I can repair my oscilloscope! |
| boogiepopgq:
Hi there! Sorry, you know how to add languages that were there before and no longer after a Recovery, is that now only German and French appear when before it had 8 languages next to English, I already contacted the Hantek service but I have been doing that for days and no idea if will respond. Thanks! |
| Steve007iii:
--- Quote from: boogiepopgq on July 29, 2021, 03:52:02 am ---Hi there! Sorry, you know how to add languages that were there before and no longer after a Recovery, is that now only German and French appear when before it had 8 languages next to English, I already contacted the Hantek service but I have been doing that for days and no idea if will respond. Thanks! --- End quote --- They take around 3 weeks to attend and the support service is not good. :-BROKE Since recovery works for you, I would recommend a force update for the uart port. This should solve the problem :-+ |
| boogiepopgq:
--- Quote from: Steve007iii on July 29, 2021, 04:53:57 am --- --- Quote from: boogiepopgq on July 29, 2021, 03:52:02 am ---Hi there! Sorry, you know how to add languages that were there before and no longer after a Recovery, is that now only German and French appear when before it had 8 languages next to English, I already contacted the Hantek service but I have been doing that for days and no idea if will respond. Thanks! --- End quote --- They take around 3 weeks to attend and the support service is not good. :-BROKE Since recovery works for you, I would recommend a force update for the uart port. This should solve the problem :-+ --- End quote --- Done! Hantek already answered me and they sent me a modified firmware where I recover the eight available languages and I am as before. Thanks! |
| sadeghelect:
hi how can i active hdmi and lan port ? thanks |
| Navigation |
| Message Index |
| Next page |
| Previous page |