Products > Test Equipment

Upgrading the Hantek DSO4072C and DS4104C oscilloscopes bandwidth up to 250MHz

<< < (13/15) > >>

Steve007iii:

--- Quote from: boogiepopgq on July 28, 2021, 03:46:55 am ---Hello, I have a NAND memory programmer and others may help you. I have a DSO4254C. I don't know if the information from there works.

--- End quote ---

oh yes this works for me i plan to restore the recovery partition if you are kind enough to upload it to download it
it is the same motherboard what changes is the software...

thanks , thanks!, thanks!, thanks!,thanks!,thanks! thank you very much.

with that information I can repair my oscilloscope!

boogiepopgq:
Hi there!
Sorry, you know how to add languages ​​that were there before and no longer after a Recovery, is that now only German and French appear when before it had 8 languages ​​next to English, I already contacted the Hantek service but I have been doing that for days and no idea if will respond.

Thanks!

Steve007iii:

--- Quote from: boogiepopgq on July 29, 2021, 03:52:02 am ---Hi there!
Sorry, you know how to add languages ​​that were there before and no longer after a Recovery, is that now only German and French appear when before it had 8 languages ​​next to English, I already contacted the Hantek service but I have been doing that for days and no idea if will respond.

Thanks!

--- End quote ---

They take around 3 weeks to attend and the support service is not good.  :-BROKE

Since recovery works for you, I would recommend a force update for the uart port.

This should solve the problem  :-+

boogiepopgq:

--- Quote from: Steve007iii on July 29, 2021, 04:53:57 am ---
--- Quote from: boogiepopgq on July 29, 2021, 03:52:02 am ---Hi there!
Sorry, you know how to add languages ​​that were there before and no longer after a Recovery, is that now only German and French appear when before it had 8 languages ​​next to English, I already contacted the Hantek service but I have been doing that for days and no idea if will respond.

Thanks!

--- End quote ---

They take around 3 weeks to attend and the support service is not good.  :-BROKE

Since recovery works for you, I would recommend a force update for the uart port.

This should solve the problem  :-+

--- End quote ---

Done! Hantek already answered me and they sent me a modified firmware where I recover the eight available languages and I am as before.
Thanks!

sadeghelect:
hi
how can i active hdmi and lan port ?
thanks

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod