Products > Test Equipment
Modifying T12-952 soldering station for driving 2 tips
<< < (3/7) > >>
cosmin1:
Because the T12 tips are too long for using as tweezers, i will do it with USB iron tips, using a 4,2-5V variable power supply. It should do the job.
asis:
Hi,
Your idea makes sense.
If the source power is sufficient to power two heaters simultaneously, then it will work.
This is the design used in the TT65 PACE Tweezers.
tooki:
Pace can do that because their temperature sensor is not in series with the heater(s), so the temperature feedback will work properly. The OP wants to use tips that have a thermocouple in series with the heater: there’s no way for that to produce the correct temperature feedback.
cosmin1:
It is done exactly as i intended.
Will be back with more info after i will build the tweezers bracket and finalize the project.
cosmin1:
So... it's ok with T12 tips too.  8)

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod