Products > Test Equipment
UT612 bad accuracy for the inductor, anyone experience?
(1/1)
dzungpham0703:
I have just bought UT612.
I have a project using common filter inductor, value in hundreds mH range and try to measure it but value difference with same parts.

For example I measure the Wurth 750318652 https://www.we-online.com/components/products/datasheet/750318652.pdf, the value on the manufacturer is 100mH at 10khz, but I measure with 10khz it show 25mH.

And I try to measure some filter it show 180mH for 100mH value by manufacturer, they write it is 1khz measurement: https://www.lcsc.com/product-detail/Common-Mode-Filters_XR-XRUU9-8-100mH-V_C5358173.html.
So the error rate is 80%  |O

So I am very disappointment about the UT612.

I do it wrong or it is limitation of this device? Before by the UT612 I just read in the front page show range from 20uH-2000H and bought, it is my fault. The range is not for all frequency. 

I also try some power inductor like 33uh, 22uh and it accurate. But anythings bigger than 10mH show ridiculous value.

Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod