Products > Test Equipment
Volt input jack broke on 121GW
(1/2) > >>
nemail2:
Hi,

the input jack on my 121GW broke a while ago and I managed to smelt it together again which lasted for like a year or so but now the part has fallen off again and I just wanted to check whether this has happened to anyone else and whether there could be some replacement part available.
All the input jacks are one solid part, unfortunately. So if I'd find one fitting input jack, I'd had to mod everything a bit in order to remove the broken part of the current input jack assembly...

Any ideas? I wrote to Dave a while ago but he didn't respond, unfortunately (no offense taken)...

Thanks yall!
tautech:
Oh another one.  :(
Quote this post for Dave to see:
https://www.eevblog.com/forum/testgear/eevblog-121gw-multimeter-issues/msg2792850/#msg2792850
nemail2:

--- Quote from: tautech on February 04, 2021, 07:36:19 pm ---Oh another one.  :(
Quote this post for Dave to see:
https://www.eevblog.com/forum/testgear/eevblog-121gw-multimeter-issues/msg2792850/#msg2792850

--- End quote ---

thanks, I did that but unfortunately Dave didn't respond yet. I really hope that he'll send me a replacement jack. I'd even pay for it...
drussell:

--- Quote from: nemail2 on February 07, 2021, 12:02:14 am ---thanks, I did that but unfortunately Dave didn't respond yet. I really hope that he'll send me a replacement jack. I'd even pay for it...
--- End quote ---

Did you send an e-mail to his main address, as requested below?


--- Quote ---Email me dave AT eevblog DOT com with 121GW Connector in the title and your address and I'll ship you a new one.
--- End quote ---
J-R:
For documentation purposes, were you using UEi or Brymen test leads?
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod