EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: Faringdon on October 30, 2023, 03:56:38 pm

Title: Weller WD1 solder station with WP80 pencil not working
Post by: Faringdon on October 30, 2023, 03:56:38 pm

Hi,
[EDIT..OK its back working again...just had to press both up and down buttons together.]
I just upped the temperature on the weller iron, and it then reports "OFF"....and has gone cold. Do you know what has happened?...is it "take it apart time"?
I have been using this iron without problem for the last 4 months.
Any known fixes for these?

Title: Re: Weller WD1 solder station with WP80 pencil not working
Post by: Performa01 on October 30, 2023, 05:25:50 pm

Weller users should be aware that their stations don't provide a separate channel on/off switch, but pressing both the up and down buttons at the same time serves this purpose.