Products > Test Equipment
Weller WD1 solder station with WP80 pencil not working
(1/1)
Faringdon:
Hi,
[EDIT..OK its back working again...just had to press both up and down buttons together.]
I just upped the temperature on the weller iron, and it then reports "OFF"....and has gone cold. Do you know what has happened?...is it "take it apart time"?
I have been using this iron without problem for the last 4 months.
Any known fixes for these?
Performa01:
Weller users should be aware that their stations don't provide a separate channel on/off switch, but pressing both the up and down buttons at the same time serves this purpose.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod