Products > Test Equipment

Weller WD1 solder station with WP80 pencil not working

(1/1)

Faringdon:
Hi,
[EDIT..OK its back working again...just had to press both up and down buttons together.]
I just upped the temperature on the weller iron, and it then reports "OFF"....and has gone cold. Do you know what has happened?...is it "take it apart time"?
I have been using this iron without problem for the last 4 months.
Any known fixes for these?

Performa01:
Weller users should be aware that their stations don't provide a separate channel on/off switch, but pressing both the up and down buttons at the same time serves this purpose.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod