What are Tek 2430A bezel dimensions?

[rbm]

Hi, 
I need to know the dimensions (height and width) of the screen bezel for a Tektronics 2430A.  I don't own or have access to one and this info is not available in the manuals I can find online.  The dimensions I'm after are outside edge to edge of the bezel surround.  Would someone be able to post this?

[kc9qvl]

Would a 2440 do yah. Should be the same. Also post a picture of from any 2430 and place marks exactly where to measure.

[David Hess]

I measured 4.15 inches tall and 5.72 inches wide for the outside dimensions of the camera mount flange with a 0.1 inch wide and 0.1 inch deep groove inset about 0.1 inches (my calipers will not clear) on the top and bottom on a 2440.  The groove on the bottom is centered and only about 1.15 inches wide which makes sense to keeping the camera mount centered.  The 22xx series match those dimensions as well within 0.01 inches so they would take the same camera adapter.

Do you mean the entire removable bezel?

[rbm]

This picture shows the dimensions I am interested in knowing:



I believe that David posted the dimensions above, based on my reading his descriptions ("outside dimensions of the camera mount flange").  Thanks very much.  The camera mount flange thickness was very helpful also.

You read my mind as well because these are needed so that I can understand whether a certain camera mount for the 2430A will work (or not work) with my Hitachi V695.

[David Hess]

Those are the dimensions I measured.

The total thickness of the camera flange is 0.3 inches with a 0.1 inch groove at the top and bottom.  The top groove runs the full length but the bottom groove is horizontally centered below the CRT and 1.15 inches long.

And like I said, the 22xx oscilloscopes have the same measurements and would take the same camera mounts.

[kc9qvl]

On my 2440 got 4 5/8" left to right ans 4 1/8" up and down