Products > Test Equipment

Which HDMI Microscope Camera and Zoom Lens for soldering

<< < (5/11) > >>

Postal2:
Sensor must be Sony only. And I'm too greedy to buy it yet. Expensive. But all another is crap.

Any cheap one will do for YouTube videos, but you won't be able to work with them.

pcprogrammer:
As promised some pictures.

The stand is 580mm high but from the front of the lens to the work surface it is maximum about 500mm. The stand has a fine tune knob to move the camera 20mm up or down from the center position.

The one I got uses a Panasonic cmos sensor. (With a Sony sensor it is ~20 euros more) For me the quality is good enough.

I made pictures at three different heights of the camera and on one of them I also used a digital zoom of 2x.

Have not yet put a SD card in the camera so no images shot with the camera itself.

Also did not verify the measurement cross on the screen.

And yes the room looks like one from a hoarder, but it just needs a tidy up.  :-DD

Postal2:

--- Quote from: pcprogrammer on August 30, 2024, 08:02:22 am ---As promised some pictures. ....

--- End quote ---
Crap.
The Eakins store on Aliexpress has a demo video of the Sony camera, it works exactly as it should. But it's expensive.

Phil1977:

--- Quote from: pcprogrammer on August 30, 2024, 08:02:22 am ---As promised some pictures.

The stand is 580mm high but from the front of the lens to the work surface it is maximum about 500mm. The stand has a fine tune knob to move the camera 20mm up or down from the center position.

The one I got uses a Panasonic cmos sensor. (With a Sony sensor it is ~20 euros more) For me the quality is good enough.

--- End quote ---
Can you tell something about latency? I have one Eakins with a panasonic 1080p sensor that has no perceptible latency at all. Then I worked with a Hayear 4k (with Sony sensor  ::) ) setup that was only set to 1080p and latency was not terrible but also not really good.

Of course latency has more to do with the image processor than with the sensor manufacturer - but I think it´s one of the key features for a soldering microscope.

@Postal2: Can you live out your general life frustration somewhere else? Why do you call setups of other people crap even if they are satisfied?

Postal2:

--- Quote from: Phil1977 on August 30, 2024, 08:13:09 am ---@Postal2: Can you live out your general life frustration somewhere else? Why do you call setups of other people crap even if they are satisfied?

--- End quote ---
These people are not satisfied, but try to deceive others by pushing bad solutions.


--- Quote from: Phil1977 on August 30, 2024, 08:13:09 am ---...I have one Eakins with a panasonic 1080p sensor that has no perceptible latency at all. ....

--- End quote ---
It's no use if the eye is blind. I have a camera whose latency is fine for me, but it has poor sensitivity and that's enough.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod